184_notes:ind_i

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision		 Previous revision
Last revisionBoth sides next revision
184_notes:ind_i [2021/06/17 16:21] – [Why do we need the negative sign?] bartonmo184_notes:ind_i [2022/11/15 16:17] – valen176
Line 11: Line 11:
  
 ===== Induced Voltage and the Electric Field ===== ===== Induced Voltage and the Electric Field =====
-We know from Faraday's Law that a changing magnetic field will create a curly electric field. If we put a loop of wire nearby, we can add up the little bits of length along that loop with the curly electric field, which tells us how curly that electric field is. (This is very similar to what we did with [[184_notes:loop|Ampere's Law]].) The units of this integral ($\int \vec{E}_{nc} \bullet d\vec{l}$) will give us the same units of electric potential (volts) - $\frac{V}{m}\cdot m= V$. However, because we have curly electric field from the changing magnetic field, this is not technically an electric potential. (When we defined the electric potential we made an assumption that all the charges were stationary or not moving, which is no longer the case.)+We know from Faraday's Law that a changing magnetic flux will create a curly electric field. If we put a loop of wire nearby, we can add up the little bits of length along that loop with the curly electric field, which tells us how curly that electric field is. (This is very similar to what we did with [[184_notes:loop|Ampere's Law]].) The units of this integral ($\int \vec{E}_{nc} \bullet d\vec{l}$) will give us the same units of electric potential (volts) - $\frac{V}{m}\cdot m= V$. However, because we have curly electric field from the changing magnetic field, this is not technically an electric potential. (When we defined the electric potential __//we made an assumption that all the charges were stationary or not moving,//__ __//**which is no longer the case.)**//__
  
 [{{  184_notes:week12_9.png?250|The curly electric field around a loop}}] [{{  184_notes:week12_9.png?250|The curly electric field around a loop}}]
Line 47: Line 47:
 Let's suppose that the induced current flows counter-clockwise in the loop (shown in the figure above). If we use our original right hand rule for magnetic force ($\vec{F} = \int I d\vec{l} \times \vec{B}$), we should get a force on the bar that points in the negative x-direction. This means that the magnetic force on the induce current would act to //slow down// the moving bar. With the bar slowing down, this is actually good for energy conservation. It means that we have to put energy into the system to keep the bar moving, and in turn that mechanical energy is turned into electrical energy by inducing a current. If you stopped moving the moving the bar, it would eventually slow down and come to rest. This tells us by energy conservation - the induced current should flow counter-clockwise around the loop. If we had instead hypothesized that the induced current flowed in a clockwise direction, we would instead get a force in the +x direction. This would mean that the bar would continually speed up, which induces more current, which then causes the bar to speed up even more! This would completely break energy conservation and mean that you are essentially creating energy out of nothing. This simply cannot happen. So we know that the induced current must be counter-clockwise in our loop.  Let's suppose that the induced current flows counter-clockwise in the loop (shown in the figure above). If we use our original right hand rule for magnetic force ($\vec{F} = \int I d\vec{l} \times \vec{B}$), we should get a force on the bar that points in the negative x-direction. This means that the magnetic force on the induce current would act to //slow down// the moving bar. With the bar slowing down, this is actually good for energy conservation. It means that we have to put energy into the system to keep the bar moving, and in turn that mechanical energy is turned into electrical energy by inducing a current. If you stopped moving the moving the bar, it would eventually slow down and come to rest. This tells us by energy conservation - the induced current should flow counter-clockwise around the loop. If we had instead hypothesized that the induced current flowed in a clockwise direction, we would instead get a force in the +x direction. This would mean that the bar would continually speed up, which induces more current, which then causes the bar to speed up even more! This would completely break energy conservation and mean that you are essentially creating energy out of nothing. This simply cannot happen. So we know that the induced current must be counter-clockwise in our loop. 
  
-Determining the direction of the induced current just based on the magnetic flux can be tricky because there are a lot of different parts to the equation. In the next page of notes, we will walk through a new right hand rule for the induced current step-by-step. +Determining the direction of the induced current just based on the magnetic flux can be tricky because there are a lot of different parts to the equation. In the next page of notes, we will walk through a **new right hand rule** for the induced current step-by-step. 
  
 /* For this right hand rule, you want to first point your right thumb in the direction of the change in magnetic flux. For our example, the change in magnetic flux would point into the page. (Because $\Delta \Phi_{B}= \Phi_{Bf}-\Phi_{Bi}$, we would have a large flux into the page as the final minus a small flux into the page as the initial, which leaves the change in flux as into the page.) Because the induced current would point opposite to the change, you would flip your thumb in the opposite direction, so pointing out of the page. Finally the direction that your fingers would curl in would be the direction of the induced current. So in our example, the current would flow counter-clockwise around the loop (shown in the figure to the left).  */ /* For this right hand rule, you want to first point your right thumb in the direction of the change in magnetic flux. For our example, the change in magnetic flux would point into the page. (Because $\Delta \Phi_{B}= \Phi_{Bf}-\Phi_{Bi}$, we would have a large flux into the page as the final minus a small flux into the page as the initial, which leaves the change in flux as into the page.) Because the induced current would point opposite to the change, you would flip your thumb in the opposite direction, so pointing out of the page. Finally the direction that your fingers would curl in would be the direction of the induced current. So in our example, the current would flow counter-clockwise around the loop (shown in the figure to the left).  */
  • 184_notes/ind_i.txt
  • Last modified: 2022/11/15 16:21
  • by valen176