course_planning:183_projects:f19_fab_project_1 [Projects & Practices in Physics]

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
Using the data from the first 20 seconds, we compute the velocity and acceleration of both the train ($X,V,A$) and car ($x,v,a$):
^ Time ^ Train Pos. ($X$) ^ Car Pos. ($x$) ^ Train Vel. ($V$) ^ Car Vel. ($v$) ^ Train Accel. ($A$) ^ Car Accel. ($a$) ^ 
| 0 s | 2536.40 m | 10.47 m |  |  |  |  |
|   |           |         | 53.64 m/s | 3.141 m/s |
| 10 s | 3072.80 m | 41.88 m |   |   | 0 m/s/s  | 0.2093 m/s/s |
|   |           |         | 53.64 m/s | 5.243 m/s | 
| 20 s | 3609.20 m | 94.22 m |   |   |   |   |

<WRAP tip>
== Tutor Questions ==
  * **Question:** At what time(s) are the average velocities for the train equal to the observed velocity of the car? How do you know?
  * **Expected Answer:** These velocities occurs at 5s and 15s. Because this train moves under constant force motion, we know that the average velocity and the arithmetic average velocity are the same, and the instantaneous velocity occurs halfway between the two time points because it changes linearly.
</WRAP>

Now, to make things as simple as possible, we assume that the car not only starts from rest, but also accelerates uniformly (constant force from the engine) throughout the duration of its interception.  Accordingly, the positions in time for both vehicles are given by $$X(t)=X_{0{\rm s}}+V t\qquad\mbox{and}\qquad x(t)=x_{0{\rm s}}+\frac{1}{2}at^{2}.$$  Since we want to find the time at which the vehicles are at the same location, we set the above equations equal and solve for the time: $$t_{\rm jump}=\frac{V\pm\sqrt{V^{2}+2a(X_{0{\rm s}}-x_{0{\rm s}})}}{a}\approx 555.979\,{\rm s}.$$

It then follows, plugging this time back into either position equation, that the location of interest is $$x_{\rm jump}\approx 32359\,{\rm m,}$$ quite a ways away.

<WRAP tip>
== Tutor Questions ==
  * **Question:**  What assumptions did you make about the motion of the vehicles?
  * **Expected Answer:**  That the train has a constant velocity, and the car starts from rest with a constant acceleration.

  * **Question:**  Are these velocities and accelerations calculated from the numbers given exact?
  * **Expected Answer:**  No, we would need to take measurements a lot closer together.

  * **Question:**  Is the predicted position of the car a good one?
  * **Expected Answer:**  Not really, basing the trajectory off the first 20 seconds of data is probably not the best -- but it is all we have to work with.

  * **Questions:**  Can you draw a plot of position vs. time for both vehicles?  What are the important features of this graph?
  * **Expected Answer:**  The point where the two curves cross is when we should jump.  One should be linear, the other quadratic.

  * **Questions:**  Can you draw a plot of velocity vs. time for both vehicles?  What are the important features of this graph?
  * **Expected Answer:**  The acceleration is the slope of each curve (constant in both cases).
</WRAP>

<WRAP alert>
== Main Points ==
  
  * Students should be able to recognize and justify the types of motion that the two vehicles are executing (constant velocity vs. constant force).
  * Students should be able to set up that relate the position and time of each vehicle and solve them as simultaneous equations for when they are in the same location.
  * Students should be able to draw the motion of both vehicles (position/velocity vs time) and explain how these graphs represent the motion given their assumptions. //It is very important that students discuss and sketch the motion of the two hovercrafts, so please ask these tutor questions even if you are pressed for time.//
</WRAP>

<WRAP info>
== Common Difficulties ==
  * Some groups struggle to extract information from the table to determine what kind of motion is being executed by each vehicle.
  * Solving these simultaneous equations can provide a bit of a challenge for some groups. You may remind them that [[http://www.wolframalpha.com|WolframAlpha]] is useful tool to check (or do) that work.
  * Students should be pushed to graph a fairly quantitatively correct graph of the motion of each vehicle. Extract meaning from their equations to do this can prove challenging.
</WRAP>